Hyundai Ioniq (AE): Input shaft speed sensor 1 / Specifications
| Specification |
|
Item
|
Specification
|
| Type | Hall effect sensor |
| Operation condition (°C)°F | -40 to 257 °F (-40 to 125 °C ) |
| Output signal (mA) | High: 11.8 - 16.8 |
| Low: 5.9 - 8.4 |
Components1. Input shaft speed sensor (Odd)2. Input shaft speed sensor (Even)
Description• Components location : DCT (Dual Clutch Transmission)• Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM).
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Repair procedures
Inspection1.Turn the ignition switch OFF.2.Disconnect the temperature control actuator connector.3.Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.Verify that the temperature control actuator operates to the warm position when connected in reverse.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Motor. Repair procedures
Inspection1.Connect the battery voltage and check the blower motor rotation.2.If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.3.Replace the blower motor if it is proved that there is a problem with it.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Suspension System
- Jump starting procedure
- Engine Clutch System
- New on site
- Most important about car
