Hyundai Ioniq (AE): Input shaft speed sensor 2 / Specifications
| Specification |
|
Item
|
Specification
|
| Type | Hall effect sensor |
| Operation condition (°C)°F | -40 to 257 °F (-40 to 125 °C ) |
| Output signal (mA) | High: 11.8 - 16.8 |
| Low: 5.9 - 8.4 |
Components1. Input shaft speed sensor (Odd)2. Input shaft speed sensor (Even)
Description• Components location : DCT (Dual Clutch Transmission)• Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM).
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Warning Indicator. Repair procedures
RemovalWarning Indicator1.Disconnect the negative (-) battery terminal.2.Remove the mirror (A).InstallationWarning Indicator1.Install the outside mirror.2.Connect the negative (-) battery terminal.Inspection1.Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Parking Distance Warning (PDW) ON/OFF Switch. Repair procedures
Removal • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Hybrid Vehicle Engine Compartment
- Transmission Gear Oil. Repair procedures
- Description and operation
- New on site
- Most important about car
