| Troubleshooting |
| Problem Symptoms Table |
|
Symptom
|
Suspected Area
|
| No blower operation | Blower fuse |
| Blower relay | |
| Blower motor | |
| Power mosfet | |
| Blower speed control switch | |
| Wire harness | |
| No air temperature control | Engine coolant capacity |
| Heater control assembly | |
| No compressor operation | Refrigerant capacity |
| A/C fuse | |
| Compressor | |
| A/C pressure transducer | |
| A/C switch | |
| Evaporator temperature sensor | |
| Wire harness | |
| Vented air not cold | Refrigerant capacity |
| Refrigerant pressure | |
| Drive belt | |
| Compressor | |
| A/C pressure transducer | |
| Evaporator temperature sensor | |
| A/C switch | |
| Heater control assembly | |
| Wire harness | |
| Insufficient cooling | Refrigerant capacity |
| Drive belt | |
| Compressor | |
| Condenser | |
| Expansion valve | |
| Evaporator | |
| Refrigerant lines | |
| A/C pressure transducer | |
| Heater control assembly | |
| No engine idle-up when A/C switch ON | Engine ECM |
| Wire harness | |
| No air inlet control | Heater control assembly |
| No mode control | Heater control assembly |
| Mode actuator | |
| No cooling fan operation | Cooling fan fuse |
| Fan motor | |
| Engine ECM | |
| Wire harness |
SpecificationAir Conditioner item Specification CompressorTypeHES20 (Electric Scroll)Communication typeCAN communicationOil type & CapacityPOE Oil, 130 ± 10cc (4.
DescriptionThe evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. The evaporator temperature sensor has the Negative Temperature Coefficient (NTC).
Inspection1.Turn the ignition switch ON.2.Connect the GDS.3.Emit intensive light toward the photo sensor using a lamp, and check the output voltage change.4.The voltage will rise with higher intensive light and reduce with lower intensive light.1. Auto light signal2.