Hyundai Ioniq: AVN System / AVN Remote Controller. Repair procedures
1. | Check for resistance between terminals in each switch position (LH). 
[LH : Audio+B/TOOTH+VOICE]
Switch
| Connector terminal
| Resistance (±5%)
| SEEK Up
| 1-6
| 430 Ω
| SEEK Down
| 1.11 kΩ
| MODE
| 2.11 kΩ
| MUTE
| 3.11 kΩ
| Volume (+)
| 4.61 kΩ
| Volume (-)
| 6.81 kΩ
| Voice
| 10.71 kΩ
| SEND
| 18.91 kΩ
| END
| 40.91 kΩ
|
|
2. | Check for resistance between terminals in each switch position (RH). 
[RH : Trip+Cruise+SCC]
Switch
| Connector terminal
| Resistance (±5%)
| Cancel
| 2-6
| 390 Ω
| SET ( -)
| 2-6
| 610 Ω
| RES (+)
| 2-6
| 910 Ω
| Cruise ON/OFF
| 2-6
| 1.38 kw
| Group
| 1-6
| 390 Ω
| Trip Up
| 1-6
| 610 Ω
| Trip Down
| 1-6
| 910 kΩ
| ENTER
| 1-6
| 1.38 kw
| SCC ON / OFF
| 2-6
| 3.63 kw
|
|
1. | Disconnect the negative (-) battery terminal. |
2. | Remove the steering wheel assembly. (Refer to Steering System - "Steering Wheel") |
3. | Remove the steering back cover (A). 
|
4. | Remove the steering remote control connector (A). 
|
5. | Remove the steering remote control after loosening the screws. 

|
1. | Install the steering wheel remote control after connecting the connector. |
2. | Connect the negative (-) battery terminal. |
Other information:
C..
Replacement
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. •
Use a plastic panel removal tool to remove interior trim pieces without marring the surface...
Categories

1. Engine oil filler cap
2. Engine oil dipstick
3. Engine coolant cap
4. Engine coolant reservoir
5. Inverter coolant reservoir
read more