Hyundai Ioniq (AE): Body Side Molding / Front Wheel Guard. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body (Interior and Exterior) / Body Side Molding / Front Wheel Guard. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Remove the front tire.

2.	After loosening the mounting clips and remove the front wheel guard (A).

To install, reverse the removal procedure.

•	Replace any damaged clips (or pin-type retainers).

❮Rear Spoiler. Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

Rear Wheel Guard. Repair procedures❯

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

Other information:

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Evaporator Temperature Sensor. Repair procedures

Inspection1.Turn the ignition switch OFF.2.Disconnect the evaporator temperature sensor connector.3.Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.Specification Evaporator core temperature [°C (°F)] Resistance [KΩ]

Hyundai Ioniq (AE): Body Side Molding / Front Wheel Guard. Repair procedures

Other information:

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Evaporator Temperature Sensor. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Front Radar Unit. Specifications

Categories