Hyundai Ioniq: Brake System / Brake Pedal. Components and components location

1. Brake pedal member assembly 2. Stop lamp switch 3. Brake pedal arm
| 4. Brake pedal pad 5. Brake pedal stroke sensor
|
Removal1.Disconnect the brake fluid level switch connector, and remove the reservoir cap.2.Remove the brake fluid from the master cylinder reservoir with a syringe...
Removal1.Turn ignition switch OFF and disconnect the negative (-) battery cable.2.Remove the crash pad lower panel. (Refer to Body - "Crash Pad")3.Remove the knee air bag...
Other information:
Inspection[Fuel Sender] 1.Using an ohmmeter, measure the resistance between terminals 1 and 6 of sender connector (A) at each float level. Pin No Discription 1Fuel sender ground 2Fuel pressure sensor (FPS) signal input 3Fuel pressure sensor (FPS) ground (-) 4Ground 5CAN [Low] 6Fuel sender signal 7- 8Fuel pressure sensor (FPS) Power supply (+5V) 9CAN [High] 10Battery power (B+) 2...
Interior lamp AUTO cut
The interior lamps will automatically go off approximately 20 minutes after the
vehicle is turned off and the doors are closed. If a door is opened, the lamp will
go off 40 minutes after the vehicle is turned off. If the doors are locked by the
smart key and the vehicle enters the armed stage of the theft alarm system, the
lamps will go off five seconds later...
Categories
The front seat can be adjusted by using the levers located on the outside of
the seat cushion. Before driving, adjust the seat to the proper position so that
you can easily control the steering wheel, foot pedals and controls on the instrument
panel.
Forward and rearward adjustment

read more