| Components |

|
NO
|
Connector A
|
Connector B
|
Connector C
|
Connector D
|
| 1 | - | Key in switch | Wiper low relay | IGN 1 |
| 2 | - | Steering heated switch | Auto light ground | IG2 Steering heated power 1 |
| 3 | Rear left seat belt indicator | - | PAS ON Indicator | IG2 Steering heated power 2 |
| 4 | Passenger seat belt indicator | - | Steering heated indicator | IG2 Steering heated power output |
| 5 | Rear centor seat belt indicator | - | - | Room lamp |
| 6 | Rear right seat belt indicator | - | COM | Ground |
| 7 | - | - | Crash output | Power |
| 8 | - | PAS Input | Crash output | - |
| 9 | Mirror unfolding relay | Key inter lock switch | Auto light sensor | - |
| 10 | - | Sunroof open switch | NTC Sensor | RPAS Power |
| 11 | - | PAS ON Switch | Head lamp switch (High) | FPAS Power |
| 12 | - | Multifunction switch ground | Wiper int vol relay | Ground signal |
| 13 | Key solenoid | - | Front wiper switch | |
| 14 | - | - | foglamp switch | |
| 15 | ATM solenoid output | - | Wiper relay (High) | |
| 16 | - | - | Auto light (Power) | |
| 17 | Security indicator | - | Sunroof enable (High) | |
| 18 | Poket lamp output | - | - | |
| 19 | Safety powerwindow down (Low) | C-Can (Low) | - | |
| 20 | Key hole illumination | C-Can (High) | - | |
| 21 | - | B-CAN (Low) | Front wiper low backup switch | |
| 22 | - | B-CAN (High) | NTC Ground | |
| 23 | Mirror folding relay output | - | IGN 1 | |
| 24 | - | - | ACC | |
| 25 | PAS | - | ||
| 26 | - | Front wiper washer switch | ||
| 27 | - | Blade position | ||
| 28 | Defogger switch | Brake switch | ||
| 29 | - | |||
| 30 | - | |||
| 31 | - | |||
| 32 | - |
Specifications Items Specifications Rated voltageDC 12VOperating voltageDC 9 - 16VOperating temperature-22°F to 167°F (-30°C to 75°C)Dark currentSMK : 3mA / Keyless : 4mA
Circuit Diagram
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
C