Hyundai Ioniq (AE): Timing System / Crankshaft Damper Pulley. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Engine Mechanical System / Timing System / Crankshaft Damper Pulley. Repair procedures

Removal and Installation
1.
Remove the passenger seat RH front tire.
(Refer to Suspension System - "Wheel")
2.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")
3.
Remove the drive belt
(Refer to Timing System - "Drive Belt")
4.
Remove the crankshaft damper pulley (A).
Tightening torque :
65.7 - 71.6 N.m (6.7 - 7.3 kgf.m, 48.5 - 52.8 lb-ft)
+ 39 - 41°

   
•
Use the SST (09231-2M100, 09231-2J210) to remove the crankshaft damper pulley bolt.

5.
Install in the reverse order of removal.
Inspection
Check the idler for excessive oil leakage, abnormal rotation or vibration. Replace if necessary.

    Components1. Crankshaft damper pulley

    Removal and Installation1.Remove the crankshaft damper pulley.(Refer to Timing System - "Crankshaft Damper Pulley")2.Remove the front oil seal (A).3.Apply engine oil to a new oil seal lip & outer surface.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Heater Unit. Repair procedures

    Replacement    When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.1.Disconnect the negative (-) battery terminal.2.Recover the refrigerant with a recovery / recycling / charging station.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Radar Unit. Repair procedures

    Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear bumper.(Refer to Body - "Rear Bumper")3.Remove the rear corner radar unit (A) after loosening the mounting nuts.    â€¢ Take care not to separate the bracket from rear bumper when removing the rear corner radar sensor.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0175