Hyundai Ioniq (AE): Timing System / Front Oil Seal. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Engine Mechanical System / Timing System / Front Oil Seal. Repair procedures

Removal and Installation
1.
Remove the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")
2.
Remove the front oil seal (A).

3.
Apply engine oil to a new oil seal lip & outer surface.
   
•
Remove any debris from the lip portion of the oil seal.
4.
Install the front oil seal (A) using SST (09231-G2100, 09231-H1100).

   
•
Always use new oil seal.
5.
Install the crankshaft damper pulley.
(Refer to Timing System - "Crankshaft Damper Pulley")

    Removal and Installation1.Remove the passenger seat RH front tire.(Refer to Suspension System - "Wheel")2. Remove the engine room under cover.(Refer to Engine and Transaxle Assembly - "Engine Room Under Cover")3.

    Components1. Timing chain cover2. Oil control solenoid (OCS)

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation

    DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Special service tools

    Special Service Tools Tool Name / Number Illustration Description LKA Compensator(09964-C1100)Used for compensating front view camera unitBCW Sensor Correction Tool Set(09958-3T500)Used to correct the blind-spot radar unit.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.015