Hyundai Ioniq (AE): Front Bumper / Front Bumper Cover. Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Body (Interior and Exterior) / Front Bumper / Front Bumper Cover. Repair procedures

Replacement
   
•
Put on gloves to prevent hand injuries.
   
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
•
Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Loosen the bolts of the front bumper upper.

2.
Loosen the front bumper lower mounting clips.

3.
After loosening the pin-type retainers and screws on the side of front bumper (A), detach the side part of front bumper.
   
•
When you pull out the front bumper, the side part of the front bumper could be damaged by the projection.

4.
Disconnect the front bumper connector (A).

5.
Remove the front bumper cover (A).

6.
To install, reverse the removal procedure.
   
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips (or pin-type retainers).

    Component Location 1. Front bumper cover

    Component Location 1. Radiator grill

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: General safety information and caution

    General Safety Information and CautionBe careful of the following precautions when driving the vehicle using the smart cruise control system.    â€¢ The smart cruise control system may have limits in detecting distance to the vehicle ahead due to road and traffic conditions.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Troubleshooting

    Trouble Symptom ChartsTrouble Symptom 1Trouble Symptom 2 Trouble symptom Probable cause Remedy The set vehicle speed varies greatly upward or downward"Surging" (repeated alternating acceleration and deceleration) occurs after settingMalfunction of the vehicle speed se

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0229