Hyundai Ioniq: Fuel Delivery System / Fuel Pump Control Module (FPCM). Schematic diagrams

Fuel Pressure Control Module (FPCM) Terminal And Input/Output signal |

Pin No
|
Discription
|
Connected to
|
1
| Fuel sender ground
| Fuel Pump
|
2
| Fuel pressure sensor (FPS) signal input
| Fuel Pressure Sensor (FPS)
|
3
| Fuel pressure sensor (FPS) ground (-)
| Fuel Pressure Sensor (FPS)
|
4
| Ground
| Chassis Ground
|
5
| CAN [Low]
| ECM
|
6
| Fuel sender signal
| Fuel Pump
|
7
| -
| -
|
8
| Fuel pressure sensor (FPS) Power supply (+5V)
| Fuel Pressure Sensor (FPS)
|
9
| CAN [High]
| ECM
|
10
| Battery power (B+)
| Fuel Pump Relay
|
DescriptionThe fuel pump control module (FPCM) is installed on the right side of the fuel tank and controls the DC motor mounted inside the low pressure fuel pump...
Removal1.Turn the ignition switch OFF and disconnect the battery negative (-) cable.2.Remove the rear seat cushion. (Refer to Body - "Rear Seat Assembly")3...
Other information:
1. Open the liftgate, and take the towing hooks out from the tool case.
■ Front
■ Rear
2. Remove the hole cover by pressing the lower part of the cover on the front
or rear bumper.
3. Install the towing hook by turning it clockwise into the hole until it is
fully secured...
TowingIf the vehicle needs to be towed, call a professional towing service. Never tow vehicle with just a rope or chain. It is very dangerous.Emergency TowingThere are three popular methods of towing a vehicle : –
The operator loads the vehicle on the back of truck...
Categories
Adjust the steering wheel so it points toward your chest, not toward your face.
Make sure you can see the instrument cluster warning lights and gauges. After adjusting,
push the steering wheel both up and down to be certain it is locked in position.
Always adjust the position of the steering wheel before driving.
WARNING
NEVER adjust the steering wheel while driving. This may cause loss of vehicle
control resulting in an accident.

read more