Hyundai Ioniq: Hood / Hood Latch Release Handle. Repair procedures

Hyundai Ioniq (AE) 2017-2025 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle. Repair procedures

Replacement
1.
Using a socket (B), remove the hood release handle (A).

2.
To install, reverse the removal procedure.
   
Make sure the hood latch cable is connected properly.
Make sure the hood locks / unlocks and opens / closes properly.

    Hood Latch Release Handle. Components and components location

    C..

    Hood Latch. Components and components location

    C..

    Other information:

    Hyundai Ioniq (AE) 2017-2025 Service Manual: Shift Lever. Repair procedures


    Removal 1.Remove the shift lever knob & boots (A) pull both of it up. 2.Remove the floor console assembly.(Refer to Body - "Floor Console")3.Disconnect the connector (A).4.Disconnect the shift cable.(1)Disconnect the eye-end (B) after removing the snap pin (A)...

    Hyundai Ioniq (AE) 2017-2025 Service Manual: Auto Defogging Sensor. Description and operation


    DescriptionThe auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator, blower motor rpm, and mode actuator...

    Categories

    Manual adjustment

    The front seat can be adjusted by using the levers located on the outside of the seat cushion. Before driving, adjust the seat to the proper position so that you can easily control the steering wheel, foot pedals and controls on the instrument panel.

    Forward and rearward adjustment

    Hyundai Ioniq. Manual adjustment

    read more


     
    Copyright © 2025 www.hioniqae.com