Hyundai Ioniq (AE): Body (Interior and Exterior) / Hood
- Repair procedures
- Hood Assembly. Components and components location
- Hood Insulator Pad. Repair procedures
- Hood Weatherstrip. Repair procedures
- Hood Latch Release Handle. Components and components location
- Hood Latch Release Handle. Repair procedures
- Hood Latch. Components and components location
- Hood Latch. Repair procedures
Replacement • When removing the fender, wrap protective tape around a screwdriver or remover not to damage components• Put on gloves to prevent hand injuries • When removing the clips, use a clip remover.
Adjustment1.After loosening the hinge (A) mounting bolt, adjust the hood (B) by moving it up and down or from side to side and tighten the bolt.2.Adjust the hood height by moving the hood overslam bumpers (C) up and down.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: PTC Heater. Repair procedures
InspectionOperating Logic Test (Manual only)Inspect the PTC operation by confirmation logic as follows.1.Entering(1)Set the Floor mode and maximum heating position.(2)Turn off the blower switch.(3)Press the intake (recirculation) button 5 times or more.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Mode Control Actuator. Repair procedures
Inspection1.Turn the ignition switch OFF.2.Disconnect the mode control actuator connector.3.Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.Verify that the mode control actuator operates to the vent mode when connected in reverse.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Aux. Battery Saver+ (Plug-in hybrid vehicle)
- Engine Mechanical System
- Normal Maintenance Schedule
- New on site
- Most important about car
