
1. Using a flat-blade screwdriver, gently pry the lens cover from the lamp housing.
2. Remove the bulb by pulling it straight out.
3. Install a new bulb.
4. Reinstall in the reverse order.
1. Open the liftgate. 2. Gently remove the cover of the liftgate trim. 3. Remove the spoiler plug hole. 4. Disconnect the electrical connector. 5. Loosen the mounting bolts and remove the spoiler.
Map lamp and room lamp â– Map lamp (LED type) â– Room lamp (LED type) Your vehicle is equipped with LED lamps. LED lamps do not have replaceable bulbs.
Replacement1.Disconnect the negative (-) battery terminal. 2.Remove the heater and blower assembly.(Refer to Heater - "Heater Unit") 3.Remove the evaporator core cover (A) after loosening the mounting screws.4.Pull out the evaporator temperature sensor (A) from the evaporator core.
Inspection1.Turn the ignition switch OFF. 2.Disconnect the auto defogging connector. 3.Verify that the auto defogging actuator operates to the open position when connecting 12V to terminal 3 and grounding terminal 4. Verify that the auto defogging actuator operates to the close position when connected in reverse.