| Replacement |
|
|
| 1. | Remove the front bumper cover. (Refer to Front Bumper - "Front Bumper Cover") |
| 2. | Remove the fixing clip (A) and then the front bumper energy absorber (B).
|
| 3. | Separate the front bumper wiring (A).
|
| 4. | After loosening the mounting screws, remove the radiator grill upper cover (A).
|
| 5. | After loosening the mounting screws, remove the radiator upper garmish (A).
|
| 6. | After loosening the mounting screws, remove the radiator grill (A).
|
| 7. | Remove the active air flap (Refer to Engine Mechanical System - "Active Air Flap") |
| 8. | To install, reverse the removal procedure.
|
Component Location 1. Radiator grill
DescriptionThe auto defogging sensor is installed on the front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives signal from the sensor and restrains moisture and eliminate defog by controlling the intake actuator, A/C, auto defogging actuator, blower moto
Inspection1.Turn the ignition switch OFF.2.Disconnect the mode control actuator connector.3.Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.Verify that the mode control actuator operates to the vent mode when connected in reverse.