Hyundai Ioniq: Rear Door / Rear Door Belt Outside Weatherstrip. Repair procedures
1. | Pull down the rear door window glass to the lowest level by pressing the power window glass switch. |
2. | After loosening the mounting screws, remove the rear door belt outside weatherstrip (A). 
|
3. | To install, reverse the removal procedure. •
| Replace any damaged clips. |
|
|
Replacement1.Remove the rear door module.(Refer to Rear Door - "Rear Door Module")2.Remove the rear door inside handle cage (A).3.Loosen the mounting bolt and remove the rear door latch (A)...
Replacement1.Remove the rear door trim.(Refer to Rear Door - "Rear Door Trim")2.Remove the rear door belt inside weatherstrip (A).3.To install, reverse the removal procedure...
Other information:
Removal 1.Remove the shift lever knob & boots (A) pull both of it up. 2.Remove the floor console assembly.(Refer to Body - "Floor Console")3.Disconnect the connector (A).4.Disconnect the shift cable.(1)Disconnect the eye-end (B) after removing the snap pin (A)...
Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the front wheel and tire (A) from the front hub. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft)
•
Be careful not to damage the hub bolts when removing the front wheel and tire...
Categories

Adjusting the side mirrors:
1. Press either the L (driver's side) or R (passenger's side) button (1) to select
the side view mirror you would like to adjust.
read more