| Replacement |
| 1. | Remove the plug hole (B). |
| 2. | After loosening the mounting bolt, remove the front door lock (A).
|
| 3. | Remove the rear door outside handle (A) by pushing it in the direction of arrow.
|
| 4. | To install, reverse the removal procedure.
|
Component Location 1. Rear door outside handle
Component Location 1. Rear door latch
InspectionOperating Logic Test (Manual only)Inspect the PTC operation by confirmation logic as follows.1.Entering(1)Set the Floor mode and maximum heating position.(2)Turn off the blower switch.(3)Press the intake (recirculation) button 5 times or more.
Inspection1.Turn the ignition switch OFF.2.Disconnect the mode control actuator connector.3.Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.Verify that the mode control actuator operates to the vent mode when connected in reverse.