Replacement1.Remove the front door module.(Refer to Front Door - "Front Door Module")2.Remove the front door inside handle cage (A).3.Remove the front door latch assembly (A) by pulling it in the direction of the arrow.
Components 1. Rear door trim2. Rear door pull cap3. Rear door module4. Rear door belt inside weatherstrip5. Rear door panel6. Rear door belt outside weatherstrip7.
InspectionOperating Logic Test (Manual only)Inspect the PTC operation by confirmation logic as follows.1.Entering(1)Set the Floor mode and maximum heating position.(2)Turn off the blower switch.(3)Press the intake (recirculation) button 5 times or more.
Self Diagnosis1.Self-diagnosis process. • When operating the self-diagnostics, the below fault (self-diagnostics code) will blink at 0.5 seconds interval on the temperature display settings (driver's side only) and the remaining symbols are OFF .