Hyundai Ioniq: Heater Hose Pump / Repair procedures
1. | Remove the battery (-) terminal. |
2. | Remove the engine room under cover. (Refer to Engine Mechanical System - "Engine Room Under Cover") |
3. | Remove the heater hose (A) and AEWP hose (B). 
|
4. | Disconnect the lock pin to remove the heater hose pump connector (A). 
|
5. | Loosen the mounting bolts and remove the AEWP (A). Tightening torque : 18.6 - 21.6 N.m (1.9 - 2.2 kgf.m, 13.7 - 15.9 Ib-ft) |

|
6. | To install, reverse the removal procedure. •
| During key off with the cooling water at high temperature, up to 40 seconds of AEWP noise is normal. |
|
|
DescriptionIn ordinary cars, the mechanical water pump mounted on the engine for heating purposes is activated to circulate the cooling water, but in hybrid cars, AEWP is used to circulate the cooling water when the engine is not operating...
Other information:
Digital speedometer
This message shows the speed of the vehicle.
Drive Info display
At the end of each driving cycle, the Driving Info message is displayed. This
display shows the trip distance (1), the average fuel economy (2), and the remaining
vehicle range (3)...
The sunroof may need to be reset if the following conditions occur:
- The battery is discharged or disconnected or the sunroof fuse has been replaced
or disconnected
- The sunroof control lever is not operating correctly
To reset the sunroof, perform the following steps:
1...
Categories
Seat belt warning light

As a reminder to the driver, the seat belt warning light will illuminate and
warning chime will sound for approximately 6 seconds each time you place the Engine
Start/Stop button to the ON position if the seat belt is unfastened.
read more