Hyundai Ioniq: Body Side Molding / Roof Side Molding. Repair procedures
| •
| Put on gloves to prevent hand injuries. |
|
| •
| When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
|
| 1. | Using a screwdriver or remover, remove the roof side molding (A). | •
| Always replace the roof side molding to a new one. |
|
|
| 2. | To install, reverse the removal procedure. | •
| Replace any damaged clips (or pin-type retainers). |
|
|
Replacement
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
Other information:
Replacement
•
Put on gloves to prevent hand injuries.
•
When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...
DescriptionThe AAF (Active Air Flap) is located between radiator grille and radiator, and consists of an actuator and 6 air flaps. The system receives information from EMS, FATC, TCU, MCU and LDC via CAN communication . With this information, the AAF controls the motor properly and then the air flaps adjust air flow from the radiator grille...
Categories
The Driver Position Memory System is provided to store and recall the following
memory settings with a simple button operation.
- Driver's seat position
- Side view mirror position
- Instrument panel illumination intensity
read more
Side Sill Molding. Repair procedures
Sunroof