Hyundai Ioniq (AE): Tire Pressure Monitoring System / TPMS Sensor. Description and operation
| Description |
| 1. | General description WU is a sensor placed in the tire that reports pressure and temperature. The WU is mounted inside the wheels, fixed to the valve. The angle between the valve and the housing of the WU is variable. This allows adaptation to various types of rims. The Wheel Unit is made of a PCB supporting the electronic hardware and encapsulated inside a housing which is potted with polyurethane. It is self-powered by a battery and includes all systems for parameter measurement (pressure, temperature and centrifugal acceleration and optionally rotation direction), RF transmission and LF detection. To achieve the specified battery lifetime, the WU supports various measurement and transmission timings, depending on WU operation mode. For RF transmission, WU uses an internal antenna. |
| 2. | First Block Mode : When vehicle start driving, Sensor enter Mode First Block. Typical period of RF emissions is 16 sec. for 40 times for Auto-learning and Auto-location function. |
| 3. | Driving Mode : After 19 min. parking and then finishing Mode First Block mode, WU enter Driving mode. Typical period of RF emissions are 64 sec above 4g vehicle speed. |
| 4. | Parking Mode : at below 3g Vehicle speed, enter Parking mode. Typical periodicities of RF emissions are 13 hours. |
DescriptionTREAD Lamp– Tire Under Inflation / Leak Warning.1.Turn on condition– When tire pressure is below allowed threshold– When rapid leak is detected by the sensor.
Replacement1.Remove the valve core and deflate the tire.2.Push the tire as illustration below by using tive change machine.3.Loosen the nut and then remove the TPMS sensor.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Ambient Temperature Sensor. Repair procedures
Inspection1.Check the resistance of the ambient temperature sensor between terminals 1 and 2 whether it changes by changing the ambient temperature.1. Ambient Sensor (+)2. Sensor groundSpecification Ambient temperature [°C (°F)] Resistance between terminal 1 and 2 (
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Unit. Components and components location
Component Location1. Blower unit assembly Components1. Duct Seal2. Intake duct case3. Air intake door assembly4. Intake door5. Seal6. Intake duct case (A)7. Air filter cover (A)8. Intake actuator9. Air filter cover10. Air filter 11. Blower unit pad12.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Immobilizer System
- Engine Mechanical System
- Washer Fluid
- New on site
- Most important about car
