Hyundai Ioniq: ESP(Electronic Stability Program) System / Troubleshooting

Hyundai Ioniq (AE) 2017-2024 Service Manual / Brake System / ESP(Electronic Stability Program) System / Troubleshooting

Failure Diagnosis

1.	In principle, ESP and TCS controls are prohibited in case of ABS failure.

2.	When ESP or TCS fails, only the failed system control is prohibited.

3.	However, when the solenoid valve relay should be turned off in case of ESP failure, refer to the ABS fail-safe.

4.	Information on ABS fail-safe is identical to the fail-safe in systems where ESP is not installed.

Memory of Fail Code

1.	It keeps the code as far as the backup lamp power is connected. (O)

2.	It keeps the code as long as the HCU power is on. (X)

Failure Checkup

1.	Initial checkup is performed immediately after the HECU power on.

2.	Valve relay checkup is performed immediately after the IG2 ON.

3.	It executes the checkup all the time while the IG2 power is on.

Initial checkup is made in the following cases.

(1)	When no failure is detected

(2)	When ABS and ESP are not in control.

(3)	Initial checkup is not made after ECU power on.

(4)	If the vehicle speed is over 5 mph(8 km/h) when the brake lamp switch is off.

(5)	When the vehicle speed is over 24.8 mph(40 km/h).

5.	Though, it keeps on checkup even if the brake lamp switch is on.

6.	When performing ABS or ESP control before the initial checkup, stop the initial checkup and wait for the HECU power input again.

Judge failure in the following cases.

(1)	When the power is normal.

(2)	From the point in which the vehicle speed reaches 4.9 mph(8 km/h) after HECU power on.

Countermeasures In Fail

1.	Shut the system down and perform the following actions and wait for HECU power OFF.

2.	Turn the valve relay off.

3.	Do not perform any ABS/TCS/ESP functions until normal operating condition is restored.

Warning Lamp ON

1.	ABS warning lamp turns on when ABS is malfunctioning.

2.	ESP function/ warning lamp turns on when ESP is malfunctioning.

When power voltage and valve relay voltage are abnormal, input/output related failure judgment is not made.

Description and operation

Description of ESPOptimum driving safety now has a name : ESP, the Electronic Stability Program.ESP recognizes critical driving conditions, such as panic reactions in dangerous situations, and stabilizes the vehicle by wheel-individual braking and engine control intervention with no needfor actuating the brake or the gas pedal...

Front Wheel Speed Sensor. Components and components location

C..

Other information:

Hyundai Ioniq (AE) 2017-2024 Owner's Manual: Lights Mode, Wiper, Check headlight

Lights Mode This indicator displays which exterior light is selected using the lighting control. Wiper This indicator displays which wiper speed is selected using the wiper control. Check headlight (if equipped) This message is displayed if the headlamps are not operating properly...

Hyundai Ioniq (AE) 2017-2024 Service Manual: Front Wheel Speed Sensor. Repair procedures

Removal1.Loosen the wheel nuts slightly.Raise the vehicle, and make sure it is securely supported.2.Remove the front wheel and tire (A) from the front hub. Tightening torque : 107.9 - 127.5 N.m (11.0 - 13.0 kgf.m, 79.6 - 94.0 lb-ft) • Be careful not to damage the hub bolts when removing the front wheel and tire (A)...