Hyundai Ioniq (AE): Driveshaft and axle / Troubleshooting

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Driveshaft and axle / Troubleshooting

Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel bearing
Replace
Defective front suspension and steering
Adjustment or Replace
Vibartion
Wear, damage or bending of driveshaft
Replace
Driveshaft rattle and hub serration
Replace
Wear, rattle or scratching of wheel bearing
Replace
Shimmy
Defective wheel balance
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace
Excessive noise
Wear, damage or bending of driveshaft
Replace
Rattle of driveshaft and worn hub splines
Replace
Wear, rattle or scoring of wheel bearing
Replace
Loose hub nut
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace

    Special Service Tools Tool (Number and Name) Illustration Use 09495-3K000Band installerInstallation of ear type boot band09495-39100Band installerInstallation of hook type boot band09568-1S100Ball joint pullerSaperate the ball joint from the front axle09495-33000PullerRemoval of spider assembly from a drive shaft

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Duct Sensor. Repair procedures

    Inspection1.Check that the voltage values of No. 1, 2 duct sensors change1. Sensor (+ 5V)2. Sensor groundSpecification Ambient temperature [°C (°F)] Resistance (kΩ) Voltage (V) 50 (122)1.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Description and operation

    DescriptionRear corner radar is a system that uses two magnetic wave radar sensors attached on the rear panel to measure the distance from the following vehicles and provides the sensing and (visual and auditory) alarm of any vehicle coming into the blind spot.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0097