Hyundai Ioniq (AE): Driveshaft and axle
- General safety information and caution
- High voltage shut-off procedures
- Specifications
- Special service tools
- Troubleshooting
- Front Axle Assembly. Front Hub / Knuckle
- Driveshaft Assembly
- Front Driveshaft. Components and components location
- Front Driveshaft. Repair procedures
- TJ Joint. Components and components location
- TJ Joint. Repair procedures
- BJ Boot. Components and components location
- BJ Boot. Repair procedures
- Rear Axle Assembly. Rear Hub - Carrier
InspectionInverter Reservoir Cap Test1.Remove the reservoir cap and mount it on the pressure tester.2.Apply pressure of 93.16 - 122.58 kPa (0.95 - 1.25 kgf/cm², 13.
Safety PrecautionPrecautions To Take Before Servicing High Voltage System • Since hybrid vehicles contain a high voltage battery, if the high voltage system or vehicles are handled incorrectly, this might lead to a serious accidents like electric shock and electric leakage.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Photo Sensor. Description and operation
Description The photo sensor is located at the center of the defrost nozzles.The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving portion, generates an electromotive force in proportion to the amount of radiation received which is transferred to the automatic temperature control
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Front Radar Unit. Repair procedures
Removal1.Remove the front bumper.(Refer to Body - "Front Bumper")2.Disconnect the smart cruise control unit connector (A).3.Remove the smart cruise control nuit assembly (B) from thevehicle after loosening mounting bolts.Installation1.Install in the reverse order of removal.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- General Information
- Engine Mechanical System
- Engine Control/Fuel System
- New on site
- Most important about car
