| Special Service Tools |
|
Tool (Number and Name)
|
Illustration
|
Use
|
| 09495-3K000 Band installer |
| Installation of ear type boot band |
| 09495-39100 Band installer |
| Installation of hook type boot band |
| 09568-1S100 Ball joint puller |
| Saperate the ball joint from the front axle |
| 09495-33000 Puller |
| Removal of spider assembly from a drive shaft |
Specification Engine Transaxle Joint type Max. permissible angle Outer Inner Outer Inner HEV Kappa 1.
Troubleshooting Trouble Symptom Probable cause Remedy Vehicle pulls to one sideScoring of driveshaft ball jointReplaceWear, rattle or scoring of wheel bearingReplaceDefective front suspension and steeringAdjustment or ReplaceVibartionWear, damage or bending of driveshaftReplaceDriveshaft rattle and hub serrationReplaceWear, rattle or scratching of wheel bearingReplaceShimmyDefective wheel balanceAdjustment or ReplaceDefective front suspension and steeringAdjustment or ReplaceExcessive noiseWear, damage or bending of driveshaftReplaceRattle of driveshaft and worn hub splinesReplaceWear, rattle or scoring of wheel bearingReplaceLoose hub nutAdjustment or ReplaceDefective front suspension and steeringAdjustment or Replace
DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Inspection1.Connect the battery voltage and check the blower motor rotation.2.If the blower motor does not operate well, substitute with a known-good blower motor and check for proper operation.3.Replace the blower motor if it is proved that there is a problem with it.