Hyundai Ioniq (AE): Cooling System / Water Temperature Control Assembly. Components and components location
| Components |
| 1. Water temperature control (WTC) outlet fitting 2. Water temperature control (WTC) housing 3. Water temperature control (WTC) gasket 4. Water temperature control (WTC) outlet fitting gasket | 5. Water temperature sensor 6. Return & degassing pipe & hose 7. Heater pipe 8. Separate cooling thermostat |
Removal and installation1.Loosen the drain plug, and drain the engine coolant. Remove the reservoir cap to help drain the coolant faster.(Refer to Cooling System - "Coolant")2.
Removal and installationWater Temperature Control Assembly1.Disconnect the battery negative terminal.2.Loosen the drain plug, and drain the engine coolant.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Description and operation
DescriptionRear corner radar is a system that uses two magnetic wave radar sensors attached on the rear panel to measure the distance from the following vehicles and provides the sensing and (visual and auditory) alarm of any vehicle coming into the blind spot.
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Description and operation
DescriptionRear view monitor (RVM) will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up. • This system is a supplementary function only.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- If the 12 Volt Battery is Discharged (Hybrid Vehicle)
- Engine Control/Fuel System
- Immobilizer System
- New on site
- Most important about car
