Disassembly • Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system.
Engine Coolant Refilling and Bleeding [Drain] • Never remove the reservoir tank cap when the engine is hot.• Serious scalding could be caused by hot fluid under high pressure escaping from the radiator.
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
Removal1.Disconnect the negative (-) battery terminal.2.Remove the front / rear bumper cover.(Refer to Body - "Front Bumper Cover")(Refer to Body - "Rear Bumper Cover")3.Disconnect the connector (A) from the parking assist sensor.4.Remove the sensor (A) by pulling out both ends of the sensor holder.