Hyundai Ioniq (AE): Clutch Actuator Assembly / Schematic diagrams
| Circuit Diagram |
Description• Components location : DCT (Dual Clutch Transmission)• Function The clutch actuator receives signals from the Transmission Control Module (TCM) and controls the clutch.
Removal1.Turn ignition switch OFF and disconnect the battery negative (-) terminal.2.Remove the engine room under cover.(Refer to Engine Mechanical System - "Engine Room Under Cover")3.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Radar Unit. Repair procedures
Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear bumper.(Refer to Body - "Rear Bumper")3.Remove the rear corner radar unit (A) after loosening the mounting nuts. • Take care not to separate the bracket from rear bumper when removing the rear corner radar sensor.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Suspension System
- Aux. Battery Saver+ (Plug-in hybrid vehicle)
- Jump starting procedure
- New on site
- Most important about car
