Hyundai Ioniq (AE): Engine Electrical System / Troubleshooting
| Trouble Shooting |
|
Symptom
|
Suspect area
|
Remedy
|
| Vehicle indicates Ready in dash, but engine will not run when requested by the HPCU (HEV module). | Ignition coil | Inspect ignition coil, or replace as required |
| Spark plugs | Inspect spark plugs, or replace as required | |
| Ignition wiring disconnected or broken | Repair wiring, or replace as required | |
| Rough idle | Ignition wiring | Repair wiring, or replace as required |
| Ignition coil | Inspect ignition coil, or replace as required | |
| Engine hesitates / poor acceleration | Spark plugs and spark plug cables | Inspect spark plugs / cable, or replace as required |
| Ignition wiring | Repair wiring, or replace as required | |
| Poor mileage | Spark plugs and spark plug cables | Inspect spark plugs / cable, or replace as required |
|
Symptom
|
Suspect area
|
Remedy
|
| Charging warning indicator does not light with Start/Stop Button "ON" and Hybrid System off. | Fuse blown | Check fuses |
| Light burned out | Replace light | |
| Wiring connection loose | Tighten loose connection | |
| LDC problem | Check the LDC. Refer to HC group | |
| Charging warning indicator does not go out with Hybrid System on. (Battery requires frequent recharging) | Battery cable loose, corroded or worn | Inspect cable connection, repair or replace cable |
| LDC problem | Check the LDC. Refer to HC group | |
| Wiring | Repair or replace wiring | |
| Overcharge | LDC problem | Check the LDC. Refer to HC group |
| Voltage sensing wire | Repair or replace wiring | |
| Discharge | Wiring connection loose or short circuit | Inspect wiring connection, repair or replace wiring |
| LDC problem | Check the LDC. Refer to HC group | |
| Poor grounding | Inspect ground or repair | |
| Worn battery | Replace battery | |
| Abnormal parasitic draw from the vehicle | Install a current probe to measure current. It should be less than 0.05A (50mA) after Hybrid System off and waiting 10 minutes. Make sure trunk light is removed for this test. |
|
Symptom
|
Suspect area
|
Remedy
|
| Vehicle will not indicate Ready in dash at Hybrid System on. | Auxiliary 12V battery charge low | Charge or replace auxiliary 12V battery |
| Auxiliary 12V battery cables loose, corroded or worn out | Repair or replace cables | |
| Transaxle range switch (Vehicle with automatic transaxle only) | Refer to AT group-automatic transaxle | |
| Fuse blown | Replace fuse | |
| Ignition switch faulty | Replace |
SpecificationsIgnition System Items Specification Ignition coilPrimary resistance0.56 Ω ± 10 %Spark plugsTypeELR9ISP8+Gap0.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Evaporator Temperature Sensor. Description and operation
DescriptionThe evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. The evaporator temperature sensor has the Negative Temperature Coefficient (NTC).
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: General safety information and caution
General Safety Information and CautionBe careful of the following precautions when driving the vehicle using the smart cruise control system. • The smart cruise control system may have limits in detecting distance to the vehicle ahead due to road and traffic conditions.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Checking the Coolant Level
- Jump starting procedure
- Child-Protector Rear Door Locks
- New on site
- Most important about car
