| Components |

|
No
|
Connector A
|
Connector B
|
| 1 | Rear speaker (LH +) | - |
| 2 | Rear speaker (LH -) | Mic (+) |
| 3 | - | - |
| 4 | - | - |
| 5 | - | Antenna power |
| 6 | Camera power | Illumination (+) |
| 7 | Camera vidio input | MM CAN (+) |
| 8 | - | - |
| 9 | - | - |
| 10 | - | Battery (+) |
| 11 | DTC | Battery (+) |
| 12 | Steering key signal | Ground |
| 13 | Front speaker (LH +) | Ground |
| 14 | Front speaker (LH -) | - |
| 15 | Front speaker (RH -) | Mic (-) |
| 16 | Front speaker (RH +) | - |
| 17 | - | - |
| 18 | - | - |
| 19 | - | Illumination (-) |
| 20 | Camera power ground | MM CAN (-) |
| 21 | Camera video ground | - |
| 22 | - | ACC |
| 23 | - | - |
| 24 | - | - |
| 25 | - | - |
| 26 | Steering key ground | - |
| 27 | Rear speaker (RH -) | - |
| 28 | Rear speaker (RH +) | - |
| 29 | - | - |
| 30 | - | - |
| 31 | - | IGN 3 |
| 32 | Camera(NC.) /NON Camera(GND) | IGN 1 |
| 33 | Camera shield ground | - |
| 34 | - | - |
| 35 | - | - |
| 36 | - | |
| 37 | - | |
| 38 | Speed |

Component Location1. Audio unit2. Antenna feeder cable connector3. Roof antenna (Audio)4. Front door speaker5. Rear door speaker6. Antenna feeder cable7.
Removal1.Disconnect the negative (-) battery terminal.2.Remove the cluster fascia panal.(Refer to Body - "Center Fascia Panal")3.Remove the crash pad garnish RH.
DescriptionThe evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. The evaporator temperature sensor has the Negative Temperature Coefficient (NTC).
RemovalWarning Indicator1.Disconnect the negative (-) battery terminal.2.Remove the mirror (A).InstallationWarning Indicator1.Install the outside mirror.2.Connect the negative (-) battery terminal.Inspection1.Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.