Hyundai Ioniq (AE): Interior Trim / Center Pillar Trim. Repair procedures
[Center pillar lower trim]
| •
| Put on gloves to prevent hand injuries. |
|
| •
| When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
| •
| When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. |
| •
| Take care not to bend or scratch the trim and panels. |
|
| 1. | Remove the front door scuff trim. (Refer to Interior Trim - "Door Scuff Trim") |
| 2. | Remove the rear door scuff trim. (Refer to Interior Trim - "Door Scuff Trim") |
| 3. | Carefully remove the front door body side weatherstrip. |
| 4. | Carefully remove the rear door body side weatherstrip. |
| 5. | Using a screwdriver or remover, remove the center pillar lower trim (A). 
|
| 6. | To install, reverse the removal procedure. | •
| Replace any damaged clips (or pin-type retainers). |
|
|
[Center pillar upper trim]
| •
| Put on gloves to prevent hand injuries. |
|
| •
| When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
| •
| When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. |
| •
| Take care not to bend or scratch the trim and panels. |
|
| 1. | Remove the center pillar lower trim. (Refer to Interior Trim - "Center Pillar Trim") |
| 2. | Remove the anchor seat belt connector. (Refer to Restraint - "Emergency Fastening Device (EFD)") |
| 3. | Using a screwdriver or remover, remove the center pillar upper trim (A). 
|
| 4. | To install, reverse the removal procedure. | •
| Replace any damaged clips (or pin-type retainers). |
|
|
Component Location 1. Center pillar lower trim2. Center pillar upper trim
Component Location 1. Rear transverse trim
Other information:
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
DescriptionRear view monitor (RVM) will activate when the backup light is ON with the ignition switch ON and the shift lever in the R position.This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up.
•
This system is a supplementary function only.
