Hyundai Ioniq (AE): Auto Lighting Control System / Description and operation

Description
It's a system that uses illumination sensor to automatically turn ON the tail lamp and head lamp based on the change in surrounding environment's illumination condition. It activates when the vehicle enters/exits tunnel, or when the illumination condition in surrounding environment changes due to rain, snow, or fog. Precautions corresponding to the use of this system are as follows.
1.
Do not add another device on top of this device.
2.
Be sure to switch to manual during poor visibility climate, such as fog, heavy rain, or cloudy weather.
3.
Illumination intensity in an actual vehicle is not always constant, and lamp ON/OFF time may very depending on the climate, season, and surrounding environment.
4.
Use this system only during sunrise and sunset period, and manually control lamp ON/OFF for general conditions.
5.
Error may occur if light block coating that may change interior illumination is applied.

    Circuit Diagram

    InspectionCheck if the auto light control operates like a timing chart shown below. Tail lamp output and head lamp (Low) output is controlled based on the auto light sensor's input (illumination intensity) when the Auto Light Switch in Multi-Function Switch is turned ON, and the vehicle is in IGN1 or IGN2 ON Mode.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Repair procedures

    Diagnosis with GDS1.REAR CORENER RADAR system defects can be quickly diagnosed with the GDS. GDS operates actuator quickly to monitor, input/output value and self diagnosis.2.Connect the cable of GDS to the data link connector in driver side crash pad lower panel, turn the power on GDS.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Components and components location

    C

    Categories

     
    Copyright В© 2025 www.hioniqae.com - 0.0171