| Components |


Removal1.Disconnect the negative (-) battery terminal.2.separate the overhead console (A) from the roof trim after loosening the mounting screws.3.Remove the overhead console (A) after disconnecting the connector (A)Installation1.
Removal1.Disconnect the negative (-) battery terminal.2.Remove the roof trim assembly.(Refer to Body - "Roof Trim Assembly")3.Disconnect the roof antenna cable and connectors (A).
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
C