Hyundai Ioniq: Heater / emperature Control Actuator. Specifications
Door Position
|
Voltage (V)
|
Error Detecting
|
Vent
| 0.3 ± 0.15
| Low voltage : 0.1V or less High voltage : 4.9V or more
|
Defrost
| 4.7 ± 0.15
|
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch...
Inspection1.Turn the ignition switch OFF.2.Disconnect the temperature control actuator connector.3.Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7...
Other information:
DescriptionThe Power Relay Assembly (PRA) consists of the positive and negative main relays, pre-charge relay, pre-charge resistor and battery current sensor. It is located inside the battery pack assembly and controls the high voltage power circuit between the high voltage battery and inverter by the control signal of BMS ECU...
Lights Mode
This indicator displays which exterior light is selected using the lighting control.
Wiper
This indicator displays which wiper speed is selected using the wiper control.
Check headlight (if equipped)
This message is displayed if the headlamps are not operating properly...
Categories

Air bag warning labels, required by the U.S. National Highway Traffic Safety
Administration (NHTSA), are attached to alert the driver and passengers of potential
risks of the air bag system. Be sure to read all of the information about the air
bags that are installed on your vehicle in this Owners Manual.
read more