Hyundai Ioniq: Child restraint system (CRS) / Installing a Child Restraint System (CRS)
WARNING
Before installing your child restraint system always:
- Read and follow the instructions provided by the manufacturer of the
child restraint.
- Read and follow the instructions regarding child restraint systems in
this manual.
Failure to follow all warnings and instructions could increase the risk of
the SERIOUS INJURY or DEATH if an accident occurs.
WARNING
If the vehicle headrest prevents proper installation of a child seat (as described
in the child seat system manual, the headrest of the respective seating position
shall be readjusted or entirely removed.
After selecting a proper child seat for your child, check to make sure it fits
properly in your vehicle. Follow the instructions provided by the manufacturer when
installing the child seat. Note these general steps when installing the seat to
your vehicle:
- Properly secure the child restraint to the vehicle. All child restraints
must be secured to the vehicle with the lap part of a lap/shoulder belt or with
the LATCH system.
- Make sure the child restraint is firmly secured. After installing a child
restraint to the vehicle, push and pull the seat forward-and-back and side-to-side
to verify that it is securely attached to the seat. A child restraint secured
with a seat belt should be installed as firmly as possible. However, some side-toside
movement can be expected.
- Secure the child in the child restraint. Make sure the child is properly
strapped in the child restraint according to the manufacturer instructions.
CAUTION
A child restraint in a closed vehicle can become very hot.To prevent burns,
check the seating surface and buckles before placing your child in the child restraint.
When selecting a CRS for your child, always:
Make sure the CRS has a label certifying that it meets applicable Federal
Motor Vehicle Safety Standards (FMVSS 213)...
The LATCH system holds a child restraint during driving and in an accident. This
system is designed to make installation of the child restraint easier and reduce
the possibility of improperly installing your child restraint...
Other information:
Diagram System CircuitA high-capacity power module is applied to the two high-voltage motors.The power module consists of a high - speed switching circuit that is isolated from the IGBT and DIODE circuits.The capacity of the high-voltage battery is approx...
Interior lamp AUTO cut
The interior lamps will automatically go off approximately 20 minutes after the
vehicle is turned off and the doors are closed. If a door is opened, the lamp will
go off 40 minutes after the vehicle is turned off. If the doors are locked by the
smart key and the vehicle enters the armed stage of the theft alarm system, the
lamps will go off five seconds later...
Categories
1. Door lock/unlock button
2. Driver position memory system
3. Side view mirror control switch
4. Central door lock switch
read more