Hyundai Ioniq (AE): Engine Control System / Knock Sensor (KS). Repair procedures

Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS). Repair procedures

Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
3.
Remove the installation bolt (A), and then remove the sensor from the cylinder block.

Installation
   
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Install in the reverse order of removal.
Knock sensor installation bolt :
18.6 - 23.5 N.m (1.9 - 2.4 kgf.m, 13.7 - 17.4 lb-ft)

    Circuit Diagram

    DescriptionHeated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: PTC Heater. Repair procedures

    InspectionOperating Logic Test (Manual only)Inspect the PTC operation by confirmation logic as follows.1.Entering(1)Set the Floor mode and maximum heating position.(2)Turn off the blower switch.(3)Press the intake (recirculation) button 5 times or more.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Special service tools

    Special Service Tools Tool Name / Number Illustration Description LKA Compensator(09964-C1100)Used for compensating front view camera unitBCW Sensor Correction Tool Set(09958-3T500)Used to correct the blind-spot radar unit.

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0161