Hyundai Ioniq: Body Side Molding / Quarter Garnish. Repair procedures

Hyundai Ioniq (AE) 2017-2024 Service Manual / Body (Interior and Exterior) / Body Side Molding / Quarter Garnish. Repair procedures

Replacement

•	Put on gloves to prevent hand injuries.

•	When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.

•	Take care not to scratch the body surface.

1.	Using a screwdriver or remover, remove the quarter garnish (A).

To install, reverse the removal procedure.

•	Replace any damaged clips.

Delta Garnish. Repair procedures

Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components...

Rear Spoiler. Components and components location

C..

Other information:

Hyundai Ioniq (AE) 2017-2024 Service Manual: Camshaft Position Sensor (CMPS). Troubleshooting

Signal WaveformThis example shows a typical Crankshaft Position Sensor (CKPS) and Camshaft Position Sensor (CMPS) waveform at idle. The PCM controls the injection and ignition timing by using these signals. Generally CKPS signal is used to detect the piston's position and CMPS signal is used to detect the Top Dead Center of each cylinder...

Hyundai Ioniq (AE) 2017-2024 Service Manual: Front Door Belt Inside Weatherstrip. Repair procedures

Replacement1.Remove the front door trim.(Refer to Front Door - "Front Door Trim")2.Remove the front door belt inside weatherstrip (A).3.To install, reverse the removal procedure. • When installing, install it by first contacting the inside part (basis point of assembly) of arrow to door frame...