Hyundai Ioniq (AE): Body (Interior and Exterior) / Body Side Molding
- Delta Garnish. Repair procedures
- Quarter Garnish. Repair procedures
- Rear Spoiler. Components and components location
- Rear Spoiler. Repair procedures
- Front Wheel Guard. Repair procedures
- Rear Wheel Guard. Repair procedures
- Waist Line Molding. Repair procedures
- Side Sill Molding. Repair procedures
- Roof Side Molding. Repair procedures
Replacement[Rear door side weatherstrip]1.Loosen the rear door checker (B) mounting bolt. Tightening torque : 16.7 - 21.6 N.m (1.7 - 2.
Replacement • Put on gloves to prevent hand injuries. • When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Auto Defoging Actuator. Description and operation
DescriptionThe auto defogging sensor is installed on front window glass. The sensor judges and sends signal if moisture occurs to blow out wind for defogging. The air conditioner control module receives a signal from the sensor and restrains moisture and eliminates defog by the intake actuator, A/C, auto defogging actuator, blower motor rpm and mod
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Warning Indicator. Repair procedures
RemovalWarning Indicator1.Disconnect the negative (-) battery terminal.2.Remove the mirror (A).InstallationWarning Indicator1.Install the outside mirror.2.Connect the negative (-) battery terminal.Inspection1.Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Engine Control/Fuel System
- If the 12 Volt Battery is Discharged (Hybrid Vehicle)
- Troubleshooting
- New on site
- Most important about car
