| Removal |
| 1. | Disconnect the negative (-) battery terminal. |
| 2. | Remove the outside rear combination lamp assembly (B) after disconnecting the connector (A).
|
| 3. | Remove the bulb (A) after turning it in the counter clock-wise direction. [LED Type]
[Bulb Type]
|
| 4. | Disconnect the inside rear combination lamp connector after removing the rear combination lamp cover. |
| 5. | Remove the inside rear combination lamp assembly after loosening the nuts.
|
| 6. | If it is necessary to replace the bulb, remove the bulb after removing the tailgate cover.
|
| Installation |
| 1. | Install the inside combination lamp assembly after assembling the bulb. |
| 2. | Install the rear combination lamp assembly after assembling the bulbs and connecting the lamp connector. |
Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear spoiler assembly.(Refer to Body - "Tail Gate Trim")3.Disconnect the high mounted stop lamp connector.
Inspection1.Turn the ignition switch OFF.2.Disconnect the temperature control actuator connector.3.Verify that the temperature control actuator operates to the cool position when connecting 12V to terminal 3 and grounding terminal 7.Verify that the temperature control actuator operates to the warm position when connected in reverse.
Replacement1.Disconnect the air damper (A) from the glove box (B).2.Remove the stopper (B) from the glove box (A).3.Remove the filter cover (A) by pressing the knob.4.Replace the air filter (A) with a new one according to the direction of air filter. • To remove the filter easily, press the right side inwa