Hyundai Ioniq: Rear Door / Rear Door Module. Repair procedures
1. | Remove the rear door window glass. (Refer to Rear Door - "Rear Door Window Glass") |
2. | Remove the rear door outside handle. (Refer to Rear Door - "Rear Door Outside Handle") |
3. | Loosen the rear door outside handle base mounting bolt (A). Tightening torque : 2.0 - 2.9 N.m (0.2 - 0.3 kgf.m, 1.4 - 2.2 lb-ft) |

|
4. | Loosen the rear door latch mounting screws. Tightening torque : 6.9 - 10.8 N.m (0.7 - 1.1 kgf.m, 5.0 - 8.0 lb-ft) |

|
5. | After loosening the mounting bolts, remove the rear door module (A). Tightening torque : 8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft) |

|
6. | Remove the rear door latch assembly. (Refer to Front Door - "rear Door Latch") |
7. | Reomove the rear speaker . (Refer to Body Electrical System - "Speakers") |
8. | Remove the rear power window motor. (Refer to Body Electrical System - "Power Window Motor") |
9. | To install, reverse the removal procedure. •
| Make sure connectors are connected properly and each rod is connected securely. |
•
| Make sure the door locks / unlocks and opens / closes properly. |
|
|
Other information:
DescriptionThe Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt helps to reduce the severity of injury to the front seat occupants by retracting the seat belt webbing...
Removal
Handling wireless charging system parts by wet hands may cause electric shock.1.Disconnect the negative (-) battery terminal.2.Remove the floor console tray (A).(Refer to Body - "Floor Console Assembly")3.Disconnect the connectors (A) from the floor console tray...
Categories

The seatback pocket is provided on the back of the front passenger's seatback.
WARNING
To prevent the Occupant Classification System from malfunctioning:
read more