Hyundai Ioniq: ETC (Electronic Throttle Control) System / Repair procedures
Throttle Position Sensor (TPS)
1. | Connect the GDS on the Data Link Connector (DLC). |
2. | Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T. Specification : Refer to "Specification" |
|
ETC Motor
1. | Turn the ignition switch OFF. |
2. | Disconnect the ETC module connector. |
3. | Measure resistance between the ETC module terminals 1 and 2. |
4. | Check that the resistance is within the specification. Specification : Refer to "Specification" |
|
1. | Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. | Remove the air cleaner assembly (Refer to Engine Mechanical System - "Air Cleaner") |
3. | Disconnect the ETC module connector (A). |
4. | Remove the ETC module (B) from the engine after loosening the bolts. 
|
•
| Install the component with the specified torques. |
•
| Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing. |
|
1. | Install in the reverse order of removal. Electronic throttle body Installation bolt : 7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.7 - 7.2 lb-ft) |
|
ETC Module Learning Procedure
When installing new ETC module or re-installing it, ETC module learning procedure must be performed.
1. | Hold the ignition key or the start button at th IG ON position during 5 seconds. |
2. | Turn ignition swich OFF and then start the engine. •
| DTC codes (P0638, P2110) might be displayed if ETC module learning procedure does not performed after replacing ETC module. |
|
|
Other information:
Opening the fuel filler door
The fuel filler door must be opened from inside the vehicle by pushing the fuel
filler door open switch.
1. Turn the vehicle off.
2. Push the fuel filler door open switch.
3. Wait until the fuel tank is depressurized.
The message "Fuel door open" is displayed when the fuel filler door opens after
the fuel tank is depressurized...
Removal1.Disconnect the negative (-) battery terminal.2.Remove the cluster fascia panal.(Refer to Body - "Center Fascia Panal")3.Remove the crash pad garnish RH.(Refer to Body - "Crash Pad Garnish")4.Remove the AVN assembly (A) after loosening mounting screws...
Categories

1. Engine oil filler cap
2. Engine oil dipstick
3. Engine coolant cap
4. Engine coolant reservoir
5. Inverter coolant reservoir
read more