| Circuit Diagram |

Signal Waveform
Inspection1.Connect the GDS on the Data Link Connector (DLC).2.Measure the output voltage of the MAPS at idle and IG ON. Specification : Refer to "Specification"Removal 1.
DescriptionThe mode control actuator is located at the heater unit.It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
DescriptionThe smart cruise control unit is installed on the front right side of the chassis. A radar sensor is embedded in the front section of the unit. This sensor detects vehicles and objects in front of the vehicle. The radar sensor can detect up to 64 objects ahead of a vehicle.