Hyundai Ioniq (AE): Input shaft speed sensor 1 / Specifications
| Specification |
|
Item
|
Specification
|
| Type | Hall effect sensor |
| Operation condition (°C)°F | -40 to 257 °F (-40 to 125 °C ) |
| Output signal (mA) | High: 11.8 - 16.8 |
| Low: 5.9 - 8.4 |
Components1. Input shaft speed sensor (Odd)2. Input shaft speed sensor (Even)
Description• Components location : DCT (Dual Clutch Transmission)• Function The input shaft speed sensor is important in that it detects the input shaft RPM and sends this information to the Transmission Control Module (TCM).
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Evaporator Temperature Sensor. Description and operation
DescriptionThe evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. The evaporator temperature sensor has the Negative Temperature Coefficient (NTC).
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: emperature Control Actuator. Description and operation
DescriptionThe temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows. The signal from the control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temper
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Hybrid Vehicle Engine Compartment
- Components and components location
- Jump starting procedure
- New on site
- Most important about car
