Hyundai Ioniq: Roof Trim / Sunvisor. Repair procedures
•
| Put on gloves to prevent hand injuries. |
|
•
| When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components. |
•
| When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface. |
•
| Take care not to bend or scratch the trim and panels. |
|
1. | Loosen the mounting screw and seperate the sunvisor (A). 
|
2. | Loosen the mounting screws and remove the retainer (A). 
|
3. | To install, reverse the removal procedure. •
| Replace any damaged clips (or pin-type retainers). |
|
|
Other information:
Inspection1.Turn the ignition switch OFF.2.Disconnect the IATS connector.3.Measure resistance between the IATS terminals 3 and 4.4.Check that the resistance is within the specification. Specification : Refer to "Specification"Removal 1.Turn ignition switch OFF and disconnect the negative (-) battery cable...
This warning light illuminates:
When you place Engine Start/Stop button to the ON position.
- It illuminates for approximately 3 seconds and then goes off.
When one or more of your tires are significantly underinflated.
This warning light remains ON after blinking for approximately 60 seconds, or
repeatedly blinks ON and OFF in 3 second intervals:
• When there is a malfunction with the TPMS...
Categories

Air bag warning labels, required by the U.S. National Highway Traffic Safety
Administration (NHTSA), are attached to alert the driver and passengers of potential
risks of the air bag system. Be sure to read all of the information about the air
bags that are installed on your vehicle in this Owners Manual.
read more