| Replacement |
|
|
| 1. | Using a screwdriver or remover, remove the tailgate lower trim (A).
|
| 2. | To install, reverse the removal procedure.
|
|
|
| 1. | Using a screwdriver or remover, remove the tailgate upper trim (A).
|
| 2. | To install, reverse the removal procedure.
|
|
|
| 1. | Using a screwdriver or remover, remove the tailgate center trim (A).
|
| 2. | To install, reverse the removal procedure.
|
|
|
| 1. | Remove the tailgate upper trim. |
| 2. | Remove the tailgate center trim. |
| 3. | After loosening the mounting screw, then remove the tailgate side trim (A).
|
| 4. | To install, reverse the removal procedure.
|
Component Location1. Tailgate trim
Component Location 1. Tailgate latch assembly
Removal1.Disconnect the negative (-) battery terminal.2.Remove the front view camera cover (A).3.Disconnect the front view camera connector (A).4.Remove the front view camera after disengaging the mounting bracket (A).Installation1.Align front view camera with windshield bracket using forward edge point (A).
Removal1.Disconnect the negative (-) battery terminal.2.Remove the rear bumper.(Refer to Body - "Rear Bumper")3.Remove the rear corner radar unit (A) after loosening the mounting nuts. • Take care not to separate the bracket from rear bumper when removing the rear corner radar sensor.