Hyundai Ioniq (AE): Warning and Indicator Lights / Turn Signal, High Beam, Light ON Indicator Lights

Turn Signal Indicator Light

Hyundai Ioniq. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light blinks:

• When you operate the turn signal indicator light.

If any of the following occurs, there may be a malfunction with the turn signal system.

- The turn signal indicator light illuminates but does not blink
- The turn signal indicator light blinks rapidly
- The turn signal indicator light does not illuminate at all

If either of these conditions occur, have your vehicle inspected by an authorized HYUNDAI dealer.

High Beam Indicator Light

Hyundai Ioniq. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light illuminates:

  • When the headlamps are on and in the high beam position.
  • When the turn signal lever is pulled into the Flash-to-Pass position.

Light ON Indicator Light

Hyundai Ioniq. Turn Signal, High Beam, Light ON Indicator Lights

This indicator light illuminates:

• When the tail lights or headlamps are on.

    This indicator light illuminates for up to 30 seconds: • When the vehicle detects the smart key in the vehicle with the Engine Start/Stop button in the ACC or ON position.

    High Beam Assist (HBA) indicator light This indicator light illuminates : When the high-beam is on with the light switch in the AUTO light position.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Blower Unit. Repair procedures

    Replacement    When prying with a flat-tip screwdriver or use a prying trim tool, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.1.Disconnect the negative (-) battery terminal.2.Recover the refrigerant with a recovery / recycling / charging station.

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Rear Corner Safety ON/OFF Switch. Repair procedures

    Inspection1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the lower crash pad switch assembly (A) after disengaging the mounting clip.4.Remove the rheostat switch connector (A).

    Categories

     
    Copyright © 2026 www.hioniqae.com - 0.0211