Hyundai Ioniq (AE): LCD Display Messages / Wait until fuel door opens, Check fuel door (Plug-in hybrid vehicle)

Hyundai Ioniq (AE) 2017-2022 Owner's Manual / Convenient features of your vehicle / Instrument Cluster / LCD Display Messages / Wait until fuel door opens, Check fuel door (Plug-in hybrid vehicle)

Wait until fuel door opens (Plug-in hybrid vehicle)

Hyundai Ioniq. Wait until fuel door opens, Check fuel door (Plug-in hybrid vehicle)

This message is displayed when you attempt to open the fuel filler door with the fuel tank pressurized. Wait until the fuel tank is depressurized.

Information

It may take up to 20 seconds to open fuel filler door.

Check fuel door (Plug-in hybrid vehicle)

Hyundai Ioniq. Wait until fuel door opens, Check fuel door (Plug-in hybrid vehicle)

This message is displayed when there is a problem with the fuel filler door. Such as, when the fuel filler door does not open after 20 seconds at freezing temperature.

Information

When the fuel filler door is frozen and does not open after 20 seconds at freezing temperature, slightly tap the fuel filler door and then attempt to open it. In other cases, have your vehicle inspected by an authorized HYUNDAI dealer.

    Unplug vehicle to start (Plug-in hybrid vehicle) This message is displayed when you start the engine without unplugging the charging cable. Unplug the charging cable, and then start the vehicle.

    Fuel door open (Plug-in hybrid vehicle) This message is displayed when the fuel filler door opens after the fuel tank is depressurized. If this message is displayed, you can refuel the fuel tank.

    Other information:

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Evaporator Temperature Sensor. Description and operation

    DescriptionThe evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator from freezing by excessive cooling. The evaporator temperature sensor has the Negative Temperature Coefficient (NTC).

    Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Mode Control Actuator. Repair procedures

    Inspection1.Turn the ignition switch OFF.2.Disconnect the mode control actuator connector.3.Verify that the mode control actuator operates to the defrost mode when connecting 12V to terminal 3 and grounding terminal 4.Verify that the mode control actuator operates to the vent mode when connected in reverse.

    Categories

     
    Copyright В© 2026 www.hioniqae.com - 0.0113