| Components |

| 1. Water jacket separator |
Removal and Installation • Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system.
Removal and Installation • Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system.
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
Inspection1.Disconnect the negative (-) battery terminal.2.Remove the crash pad lower panel.(Refer to Body - "Crash Pad Lower Panel")3.Remove the lower crash pad switch assembly (A) after disengaging the mounting clip.4.Remove the rheostat switch connector (A).