Hyundai Ioniq (AE): Engine Mechanical System / Cylinder Block
- Components and components location
- Fly Wheel. Components and components location
- Fly Wheel. Repair procedures
- Water Jacket Separator. Components and components location
- Water Jacket Separator. Repair procedures
- Rear Oil Seal. Components and components location
- Rear Oil Seal. Repair procedures
- Piston and Connecting Rod. Components and components location
- Piston and Connecting Rod. Repair procedures
- Crankshaft. Components and components location
- Crankshaft. Repair procedures
- Cylinder Block. Repair procedures
RemovalEngine removal is not required for this procedure. • Be sure to read and follow the "General Safety Information and Caution" before doing any work related with the high voltage system.
Components1. Piston ring2. Piston3. Piston pin4. Connecting rod5. Connecting rod upper bearing6. Connecting rod lower bearing7. Connecting rod cap8. Cylinder block9.
Other information:
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Evaporator Temperature Sensor. Repair procedures
Inspection1.Turn the ignition switch OFF.2.Disconnect the evaporator temperature sensor connector.3.Measure the resistance between terminal "+" and "-" of the evaporator temperature sensor.Specification Evaporator core temperature [°C (°F)] Resistance [KΩ]
Hyundai Ioniq (AE) 2017-2022 Service & Repair Manual: Heater Unit. Components and components location
Component Location1. Heater unit assemblyCompoents1. Heater core cover2. Heater core & Seal assembly3. Mode actuator [LH]4. Temperature control actuator [LH]5. Shower duct [LH]6. Duct sensor [Floor]7. PTC Heater8. Duct sensor [Vent]9. Heater & Evaporator lower case10.
Categories
- Manuals Home
- Hyundai Ioniq Owners Manual
- Hyundai Ioniq Service Manual
- Washer Fluid
- Jump Starting
- General Information
- New on site
- Most important about car
