| Personal Protective Equipment |
|
Name
|
Illustration
|
Description
|
| Insulation glove |
| Used when inspecting or working on the high voltage components [Insulation performance : 1000V / 300A or above] |
| Insulation shoes |
| Used when inspecting or working on the high voltage components |
| Insulation clothes |
| |
| Insulation helmet |
| |
| Safety glasses |
| Used in the case below • During Removal & installation or inspection of the high voltage battery terminals or wiring, which spark might happen. • During working on the high voltage battery pack assembly. |
| Face shield |
| |
| Insulation mat |
| Putting the removed high voltage components on the insulation mat to prevent safety accidents. |
| Insulation sheet |
| Covering the high voltage components with insulation sheet to prevent people who don’t wear the personal protective equipment from safety accidents. |
SpecificationsHybrid Control SystemBrake Switchâ–· Type : ON/OFF Switchâ–· Specification Item Brake PedalRelease Brake PedalPush Switch 1Max.
Components1. Engine2. Hybrid Drive Motor3. HSG (Hybrid Starter Generator)4. Transaxle5. High Voltage Battery System6. Power Cable
Replacement1.Disconnect the negative (-) battery terminal. 2.Remove the heater and blower assembly.(Refer to Heater - "Heater Unit") 3.Remove the evaporator core cover (A) after loosening the mounting screws.4.Pull out the evaporator temperature sensor (A) from the evaporator core.
Service Point Target Auto Calibration (SPTAC)When you need calibration :– Front view camera is removed and mounted– Replace front view camera with a new one – Windshield glass changed– Front view camera coupler of the windshield glass is deformedService Point T